Zenmuse H3-3D Gimbal Manuale Utente Pagina 16
- Pagina / 18
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
16
©
2014 DJI. All Rights Reserved.
Appendix
Troubleshooting
Problem Cause Solution
Gimbal keeps drifting
after initialization.
1. The transmitter trims value is
beyond the acceptable limit.
2. The GCU is disconnected from the
ight control system.
3. The gimbal is not mounted correctly.
1. Adju
st the transmitter trims value.
2. Connect the GCU and ight control
system.
3. Ensure the gimbal is mounted so it
is parallel with the aircraft, and the
camera is
pointing towards the nose.
The gimbal axes are
not level.
Factory calibration error.
Contact your local dealer or DJI
customer service for assistance.
Unable to determine
gimbal orientation.
BVR (beyond visual range) ight.
Use a wireless video transmission
module.
Settings When Using the A2 Flight Control System
Users should congure the H3-3D’s pitch control in the A2 assistant when using the A2 Flight
Control System. Map the H3-3D to two channels on the transmitter as shown in the following
diagram. DJI recommends the use of a knob switch or a stick with spring back function for tilt
control, and a 2-position switch for MODE.
Zenmuse Channels
REV
0
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
ROLL
REV
0
PAN
REV
0
TILT
REV
0
MODE
REV
0
SHUT
REV
0
AUX1
REV
0
AUX2
REV
0
AUX3
Appendix
- ZENMUSE H3-3D 1
- Warning & Disclaimer 2
- Contents 3
- In The Box 4
- Installation 6
- Final Checks 8
- Camera Installation 8
- GCU Connection 9
- User Manual 10
- Video Connection 11
- Wireless Video 12
- Transmission Module 12
- Conguration 13
- Firmware Upgrade 14
- Software Upgrade 14
- Test Flight 15
- Appendix 16
- Specications 17
HTC Smartphones user manuals
Starting on S
Commenti su questo manuale